Tel: 01159 413 640
Assembling your own shelving? Follow our step by step guide below. Remember to always be safe. Wear the proper shoes and clothing. Make sure someone is assisting you. Make sure you have the right tools- a spirit level , tape measure and a rubber mallet

If you have any questions, then dont hesitate to call us at 0115 9413640
Locate the baseleg rear lug and block into the bottom "H Slots" of the upright as shown.
Using a rubber mallet, firmly knock the baseleg upwards locking it into position until flush.
Repeat steps 1 and 2 until you have two "L" shaped uprights.
Connect all "L" shaped uprights together by fitting a 1000mm back panel into the "H Slots" of the uprights. Now check levels are correct by adjusting the foot discs as required. *
Fit the plinth skirting into position by slotting it between the front capping on the baselegs.
Fit the base shelf onto the baseleg runners. Now fit all remaining back panels.
Once the base shelf and back panels are in place the bay should look as above. You are now ready to fit the upper shelves.
Insert a bracket into the upright "H" slot at an angle as shown above
Repeat step 8 on the opposite upright and then fit a matching shelf onto the pair of brackets.
Repeat steps 8 - 9 until all the upper shelves are in position.
To finish use 665mm EPOS ticket strips and cut to suit the size of the shelf. Attach the EPOS ticket strips to the front of all shelves.
To further assist your installation please see the above exploded bay configuration.

This product has been added to your cart